Designed by George Hicks and Jon Leyland, the Sobre 3D ARF has superb slow flight responsiveness so you can fly high-alpha 3D with authority. Its carbon fiber reinforced Depron foam construction that provides the solid, precise feel of a balsa profile plane without the weight. This allows you to fly the Sobre 3D ARF outside in windier conditions that would keep most other profile foamies grounded. The Sobré 3D ARF is another exciting addition to E-flite’s outstanding line of electric RC aircraft and accessories.

E-flite uses top-quality engineering and materials in everything it makes, so you always get the maximum level of value and fun. E-flite backs all of its products with the best customer service and support in the hobby so your electric flight experience is always a positive one.

About the designers: George Hicks is a full-scale aerodynamicist for Gulfstream Aerospace who combines his engineering expertise with his passion for 3D aerobatics to create some of the most successful electric foamie designs in RC. Jon Leyland is a veteran IMAC competitor who was the 2006 Masters Warm-Up Pilot.

• Laser-cut 3mm genuine Depron parts for optimum strength and minimum weight
• Lightweight carbon fiber truss system virtually eliminates flex
• Factory-installed leading and trailing edge flat carbon spars
• Designed by George Hicks and Jon Leyland
• Vibrant screen printed trim scheme
• Ideal for indoor flight and capable of outdoor flight in low winds
• Optional Side Force Generators included
• Minimal assembly required—flight ready in as little as 3 hours
• Perfect match for E-flite Park 300 or Park 370 brushless outrunner motors
• Engineered for use E-flite’s Showstopper Variable Pitch Prop System

Wing Span: 33.25 in (845mm)
Overall Length: 34.5 in (875mm)
Wing Area: 260 sq in (16.8 sq dm)
Flying Weight: 7.5-9.25 oz (215-260 g) with battery or 6.25-7.5 oz (175-215 g) without battery
Motor Size: Park 300 or Park 370 Outrunner
Radio: 6+ Channels (for proper mixing)
Servos: E-flite S60 6g sub-servos (4) plus one S75 for VPP option
Trim Scheme Colors: screen printed
CG (center of gravity): 3.5-4 in (90-100mm) back from the center of the leading edge of the wing
Prop Size: 8x3.8 or 9x4.7 Slow Flyer or Variable Pitch Prop (optional)
Hardware Included: Yes
Speed Control : 10A Brushless
Recommended Battery: 3 Cells 11.1V 480-730mAh Li-Po
Scale: Indoor 3D
Approx. Assembly Time: 3 hours
 

6-channel transmitter (for proper mixing and dual rate capabilities), Micro receiver, 4 sub-micro servos, Motor, 10A Brushless ESC, 8x3.8 or 9x4.7 Slow Flyer Prop, Battery & Charger are needed for completion.